LED technical details -- voltage etc?
Please restrict your posting in this Forum to questions for Jenney.
Jenney will answer questions in the Codex Valoria.
You may carry on discussions in the Pre-Kickstarter News and the Kickstarter 5 Discussion Forums.
Jenney will answer questions in the Codex Valoria.
You may carry on discussions in the Pre-Kickstarter News and the Kickstarter 5 Discussion Forums.
Re: LED technical details -- voltage etc?
And the shorter lived the better.
A pretty decent Docent of Valoria
- AnimeSensei
- Minotaur Lord
- Posts: 4397
- Joined: Sun Oct 27, 2013 2:03 pm
- Location: South Weber, UT






Re: LED technical details -- voltage etc?
Wow... 

Sir William of the Basalt Region of Mythras
( aka: Rock Breaker Bill - Column Barron of BRoM )
( aka: Rock Breaker Bill - Column Barron of BRoM )
Re: LED technical details -- voltage etc?
The JST connectors are larger than the 1.25 and the 2mm ones I have so I'm guessing that they are 3mm JST connectors?... not sure yet since this design was chosen at the point of manufacturing by the factory and I wasn't involved in that. I'll have to look up the JST spec sheets to match up the dimensions and then I can get an answer.GroundZero wrote: ↑Fri Jul 07, 2017 1:19 pmDo you also have the model/specs for the connectors used in KS4/5? I'm interested in doing some modding and making compatible pieces.
Also if you have a Canadian source, even better.
If you aren't gaming then you aren't living.
Re: LED technical details -- voltage etc?
If it's a question looking for an official answer then 'yes', always use a resistor.
If you aren't gaming then you aren't living.
- GroundZero
- Kobold
- Posts: 9
- Joined: Sat Mar 14, 2015 11:50 am
- Location: Ottawa, Canada


Re: LED technical details -- voltage etc?
Do you also have the model/specs for the connectors used in KS4/5? I'm interested in doing some modding and making compatible pieces.
Also if you have a Canadian source, even better.
Re: LED technical details -- voltage etc?
Thank you Josh.
Re: LED technical details -- voltage etc?
Any resistors needed? (always used them in my labs, but that was with 5V)
Re: LED technical details -- voltage etc?
I answered this in a private message, but I'll answer it here, too. It's a 3 volt button cell battery (CR2032) that's used in all the LED pieces. You can light most LEDs from that, from a 1.8mm to a 10mm LED, and even tiny surface mount LEDs.
If you aren't gaming then you aren't living.
Re: LED technical details -- voltage etc?
Question collected. Josh is the LED wizard, so he might actually be your best bet for this answer...
Who is online
Users browsing this forum: No registered users and 2 guests